Euroscreen RF AutoLink Trigger for Smart motors (Old model)

Using the Smart AutoLink The AutoLink light will be green when it detects a power usage less than the calibrated ""effect"" mode When the projector is turned on and the power exceeds the calibrated effect mode, the AutoLink will send a ""down"" signal to the screen. Now the light changes to red. When the projector is turned off to standby and the power is less than the calibrated effect mode, the AutoLink will send an ""up"" signal to the screen. The light now change back to green. Installation To pair the Autolink to a screen motor use an existing RF remote transmitter already programmed to the screen motor. NOTE! A tip is to do the pairing process separately as a step 1 and thereafter connect the Autolink to the projector to do the power calibrating process as a step 2. STEP 1 - Pair the Autolink to the screen motor Press the remote control´s ""P2"" button twice (under the battery lid) Briefly press ""P2"" on the AutoLink transmitter, the screen should now confirm with a beep and a ""jog"" The ""pairing"" process can be confirmed by rolling the screen up by using the ""UP"" button on the AutoLink transmitter STEP 2 - Cailibrating Autolink to the projector"'s power level Connect the AutoLink transmitter to the projector power input. While the projector is in ""Standby mode"", hold the ""P2"" button on the AutoLink transmitter until it beeps. Now the AutoLink transmitter is calibrated to send a trigger signal when the projector consumes +10W more than in the standby mode.